VW T5 ABS Pump 7H0907379P Coding and Replacement: What You Need to Know

VW T5 ABS Pump 7H0907379P Coding and Replacement: What You Need to Know

A correctly numbered replacement ABS pump is only one part of the job. VW T5 ABS assemblies can require diagnostic configuration after installation, so plan for coding and system checks before fitting a 7H0907379P unit.

Why coding can matter

The ABS controller communicates with other vehicle systems and its configuration can depend on the vehicle's specification. A replacement module may therefore require coding or adaptation before all functions operate correctly.

What may be required after installation

• Diagnostic communication and module identification.

• Coding or configuration to the vehicle specification.

• Basic settings/adaptation where applicable.

• Brake hydraulic bleeding if the hydraulic circuit was opened.

• Clearing stored faults and completing a post-repair scan.

Do not code around the wrong part

Coding cannot turn an incompatible hydraulic/electronic assembly into the correct one. Start with the original 7H0907379P / 7H0614117 identification and confirm the physical specification before installation.

Final checks

Confirm there are no active ABS faults, verify wheel-speed signals where appropriate and ensure warning lamps behave correctly after the repair. If braking performance is abnormal, the vehicle should not be returned to normal road use until inspected.

For the matching replacement, see the VW T5 ABS pump 7H0907379P product page.

For pre-purchase identification, read how to identify the correct 7H0907379P ABS pump.

Frequently asked questions

Does 7H0907379P fit every VW T5?

No. ABS specification varies by vehicle, braking system, engine, equipment and market. Match the complete part number and connectors against the original unit before ordering.

Is 7H0614117 the same part?

It is a closely associated VW number used with 7H0907379P on relevant T5 ABS assemblies, but the complete identification on the vehicle should be matched rather than relying on one number alone.

Will coding or adaptation be needed?

It can be. After replacement, professional diagnostic equipment may be required for coding, basic settings, bleeding and clearing stored faults depending on the vehicle and replacement unit.

What should I compare before buying?

Compare 7H0907379P, 7H0614117, connector arrangement, hydraulic block, mounting points and vehicle specification. If uncertain, provide the VIN/registration and a photograph of the original label for a compatibility check.

For the exact used unit currently listed by BVS ONLINE, see the VW T5 ABS pump 7H0907379P product page.